Those sculptures which you are going to see are from the ice sculptures presentation in Moscow. As you can see they are very nice and created with a stile. I suppose that is Russia there is a lot of snow duwing the winter I think that is not problem to build a lots of sculptures here. Here are some instructions if you decide once to building something which can look on some which are presented on those pictures.
- Wash Mold – This will remove any dirt picked up during manufacture, transport, or storage.
- Position the mold in your freezer and level with the 4 foam corners (included with mold).
- Fill the mold approximately 90%. Do not fill to top to allow for expansion.
- Freeze for 48 hours.
- To demold, place the mold open side down on a flat surface for several minutes until the mold lifts off easily. Note: Do not dip it in water as this will cause cracking.